CAMERON MODEL MD-70X

Manual Milling and Drilling Center

Standard Features:

• Reaches to the center of a 16" work piece
• Distance from bottom of collet to base plate is 9-3/8"
• Maximum distance from bottom of collet to X-Y table is 4-5/8"
• Precision small-hole drilling from 1/4 " down to 0.002"
• Collets available from 0.5mm to 6.0mm (0 .1mm increments)
• Spindle run out is within 1 micron
• Maximum Spindle Speed - 28,000 RPM
• X-Y TABLE: 15" x 4-5/8"
  • Height: 5-3/16"
  • X Travel 9 "
  • Y Travel 6
• Machine Foot Print: 20-5/8" x 18 "
• VEF 100 Video Edge Finder System: (Accuracy within 0.0005")
  • Video Head
  • Umbilical Cord
  • Monitor
  • Cross Hair Generator
  • Camera
  • Power Supplies
• Digital Readout System Resolution is 0.0002"

/\ Above: MD-70XZ

\/ Below: Start up screen on

the Auto-Z control panel

CAMERON MODEL MD70-XZ

Semi-Automated Milling and Drilling Center

Standard Features:

• Programmable Z-Axis Motor
  • Peck Rate of 0.0001"
  • Repeatable of 0.002"
• Reaches to the center of a 16" work piece
• Distance from bottom of collet to base plate is 9-3/8"
• Maximum distance from bottom of collet to X-Y table is 4-5/8"
• Precision small-hole drilling from 1/4 " down to 0.002"
• Collets available from 0.5mm to 6.0mm (0 .1mm increments)
• Spindle run out is within 1 micron
• Maximum Spindle Speed - 28,000 RPM
• X-Y TABLE: 15" x 4-5/8"
  • Height: 5-3/16"
  • X Travel 9 "
  • Y Travel 6
• Machine Foot Print: 20-5/8" x 18 "
• VEF 100 Video Edge Finder System: (Accuracy within 0.0005")
  • Video Head
  • Umbilical Cord
  • Monitor
  • Cross Hair Generator
  • Camera
  • Power Supplies
• Digital Readout System Resolution is 0.0002"